The RWS incorporates two of Tramex's well-known moisture scanners, the Leak Seeker for Roofing, and the Wet Wall Detector for EIFS, incorporating all the benefits and features of both these time proven instruments into this one instrument.

The Tramex RWS has dual operating modes for EIFS and Roofing. Each of these modes has 2 ranges of sensitivity for both deep and low penetration sensitivity, enabling the scanning of Roofing, and EIFS, with a signal penetration ranging from the surface up to approximately 4” (100mm).

Features:

• For non-destructive moisture evaluation of roofs and EIFS building envelope
• For tracing leaks into the waterproofing membrane back to the source
• Fast and easy to operate
• Instant clear readings
• "Hold" function facilitates ease of recording readings
• Lightweight hand held and battery operated
• Inexpensive to purchase and operate when compared with other non-destructive testing methods

*Limitations

• Roofing: EPDM, Butyl rubber roofing and other conductive roofing
• EIFS: Hard Coat Stucco, wire lath or wire mesh reinforced finishes

Tramex MEP
Tramex SE
Tramex MRH
Tramex WWD
Tramex LS
Tramex SMP
Tramex COM
Tramex PTM
Tramex RWS